Introduction to the use of sheet metal bending machine:

1. First, turn on the power, turn on the key switch on the control panel, and then press the oil pump to start, so you can hear the sound of the oil pump turning. (the machine doesn't work at this time)
2. Travel adjustment, the use of bending machine must pay attention to adjust the travel, before bending must test. When the upper die of bending machine goes down to the bottom, there must be a gap of plate thickness. Otherwise, the mold and machine will be damaged. There are also electric quick adjustment and manual fine adjustment for stroke adjustment.
3. Bending notch selection, generally to choose 8 times the width of the plate thickness of the notch. For bending 4mm sheet metal, the notch of about 32 should be selected.
4. Generally, there are electric quick adjustment and manual fine adjustment for back stop adjustment, and the method is the same as that of shearing machine.
5. Press the foot switch to start bending. The bending machine is different from the shearing machine. It can be released at any time. When the foot is released, the bending machine will stop, and then step on it to continue down.